Altınok Tekstil
EN
Request a quote
☰
ProductsProductionGuideAbout usContact
GuideFabrics & applications

Which stabilizer works for towel embroidery and sunken lettering?

White embroidery on terry loops
Illustrative image

Backing supports a towel from underneath. If terry loops poke through small lettering, a suitable water-soluble topping on the face can hold the pile down during stitching. A topping and a backing perform different jobs and can be used together.

Where do backing and topping go?

Backing sits against the reverse of the towel. Topping goes on the needle side, over the loops. Altınok lists the 506 backing for trials on towels and bathrobes. Water-soluble topping is a separate supply and is not one of the 506 tear options.

Why test the smallest letters on the actual towel?

A wide area of fill can look solid while the hole in a small letter disappears into the pile. Stitch the same word on the flat border and on the looped face. If the border is legible and the looped area is not, pay special attention to surface preparation.

How should you check the finish after laundering?

  1. Run two swatches with the same backing, file and thread. Add suitable topping to just one.
  2. Remove excess topping according to its own instructions. Support the stitches when clearing film from tight spaces.
  3. Wash and dry both pieces according to the towel’s label. Once the loops lift again, inspect the spaces inside letters, the design edge and the reverse that touches the skin.

Sources

Explore the backing series

Contact us on WhatsApp